National/Technics SC-850
¥ 285,000 (around 1969)
Commentary
This is a top-of-the-line separate stereo that uses all of Technics products with the best acoustic technology.
Receiver section
All stages of the main amplifier are directly connected.
Distortion is reduced by the circuit configuration of ITL-OTL-OCL (without output capacitor).
By using a newly developed silicon transistor, high-frequency characteristics are greatly improved and noise reduction is realized.
A 4-pole MOS FET is used for the FM tuner section.
In addition to the 4-stage 5-stone IF circuit and 2-stage direct-coupled limiter circuit, we have improved the selectivity and limiter effect by using the patented PCM ceramic IFT.
Player part
A static balanced tone arm is used balance type tone arm.
The cartridge is equipped with the world's first top-grade MM type cartridge (Technics 200C/EPC-84SM) using platinum cobalt magnet.
Speaker part
The speaker system is a specially designed model of the National Acoustic Laboratory.
A 30 cm cone woofer is installed in the low range and a 12 cm cone squaker is installed in the middle range.
Two 5-cm horn type tweeters are installed in the high range.
Model Rating
Type | Separate stereo | |
Amplifier / Tuner Section | ||
Receiving frequency | FM | 76 MHz to 90 MHz |
AM | 525 kHz to 1,605 kHz | |
Receiving sensitivity | FM | 3 μ V (IHF) |
AM | 10 μ V, 500 μ V/m (IHF) | |
FM multi-circuit | Switching system | |
Output | 140 (PMPO, IHF, THD0.8%) 70W(EIA) |
|
Tone control | Bass-Trelbe | |
Accessory function | Headphone jack Tape monitor Loudness control switch External SP terminal Din connector AM/FM external antenna terminal Read / write pin terminal |
|
<Player Part> | ||
Drive system | Belt drive system | |
Drive motor | 4-pole hysteresis synchronous motor | |
Number of revolutions | 33 1/3, 45 rpm | |
Turntable | 30 cm Aluminum Die Cast | |
Cartridge | Platinum-Cobalt MM Type (Technics 200C) | |
Needle pressure | 1.5g | |
Exchange needle | EPS-50STED (Diamond Needle) | |
Tone arm | Static Balance Type, Inside Four Scan Seller, with Lateral Balancer, Oil Dump Mechanism | |
Speaker Unit | ||
Method | 3-way, 4-speaker, airtight type, bookshelf type | |
Units Used | Low band | 30 cm cone mold |
For Middle Range | 12 cm cone mold | |
High pass | 2 x 5 cm horn type | |
<General> | ||
Frequency characteristic | 30 Hz ~ 20 kHz (With Ultra Low Pass Filter) | |
Semiconductor used | Transistor : 38 Diode : 24 units |
|
Pwer | 100 VAC, 50Hz/60Hz | |
Power consumption | 140W at maximum output | |
External dimensions | Body / Record Case | Width 470x Height 480x Depth 392 mm |
Spekers | Width 470x Height 960x Depth 392 mm | |
Weight | 91kg |